MyBinding Standard 3030x Bedienerhandbuch PDF herunterladen (Seite 24)

6.0 Operation

6.9.4 Push-Out Key/Hold-To-Run Backgauge Key

This key has 2 functions. It is used to move the backgauge forward 5 inches (or to the most forward

position) and then return it to its previous position. This allows paper to be removed from the cutter

without putting hands under the knife and clamp. It also allows backgauge to move forward under

program control if the electric eyes are blocked (or front guard is raised) for dimensions less than 3.5

inches (8.9 cm).

Never place hands in the clamp and knife area. Use the push-out key or

the backgauge glide control to move the paper to an area where it can be reached.

6.9.5 Clear Key

The CLEAR key is used to clear error messages and the current entry line.

6.9.6 Enter Key

The ENTER key selects items in the maintenance mode and processes data that has been entered in

the other modes.

6.9.7 Priority Add (X/Y) Key

The priority add key is used for entering fractions when they are combined with whole numbers. The

symbol displayed when this key is pressed is the underline symbol “_”. An example of a number

entered using the priority add key is 1_1/2 (see 6.11.2 Entering Fractions, page 24).

6.9.8 Soft-Keys

The soft-keys are labeled as A, B, C, and D. The definition for these keys change depending on the

operating mode. The function of the key can be found on the bottom of the display screen.

6.9.9 Arrow Keys

The four arrow keys can be used in almost all screens. The arrow keys are primarily used for moving

the cursor around on the screen, or to toggle between highlighted selections. In some screens, the

left arrow key acts as a backspace key.

6.9.10 Contrast Control

The contrast of the display can be adjusted by using the contrast control knob, which is located

directly behind the display panel, sticking out of the display panel cover. To access, open the front

guard, reach in with your left hand until you feel the knob, and adjust the contrast as necessary.

6.10 Manual Backgauge Control

6.10.1 Backgauge Glide Control

The backgauge can be moved manually by use of the backgauge glide control. Press towards the

operator for forward travel and away from the operator for reverse travel. The further away from

center that the actuator is pushed, the faster the backgauge will travel.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 77 78

Keine Kommentare

MyBinding Standard 3030x Bedienerhandbuch Seite 24