MyBinding Standard 3030x Bedienerhandbuch PDF herunterladen (Seite 15)

5.0 Installation & Setup

5.4.2 Removing the Foot Treadle

Make sure the power is off and the power cord is disconnected. Remove the lower front cover. Use

an open-end wrench to remove the two cables attached to the base, which hold up the foot treadle.

Carefully, remove the springs. Now remove the pins at the rear pivot points of the foot treadle.

Remove the treadle.

5.4.3 Removing the Front Guard (If Equipped)

Make sure the power is off and disconnect the power cord. Open the front guard. Remove the

cylinder bracket screws (Figure 9).

Bracket

Screws

Figure 9

Then open the top hood and remove one set of hinge screws (Figure 10). Slide the front guard out of

the other hinge.

Hinge Screws

Figure 10

5.4.4 Reattaching the Table

Set the table in position. Lift the table from the front and set the two front spacers in place. Insert the

front two socket head screws, but do not tighten. Lift the table from the rear and set the two rear

spacers in place. Start the rear two socket head screws. Reinsert the two taper pins, and tap into

position so they are below bottom of the slot. Tighten all four screws. Attach the right and left side

guides (Figure 7 & Figure 8 on page 13), the presetter board assembly (Figure 6 on page 13), the

motor and encoder wires (Figure 4 & Figure 5 on page 12), and all other items that were removed.

Once the table is installed, the backgauge squareness and accuracy will have to be reset. See page

26, the Accuracy Adjust section; and page 46 the Squaring the Backgauge section.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 77 78

Keine Kommentare

MyBinding Standard 3030x Bedienerhandbuch Seite 15